THE EDP-A2 MAGNET CONTROLLER

The EPD-A2 controller is designed for AC 3-phase generators at 180 vac/phase, giving 230 VDCs to the magnet.

It can also be used at 240 vac single phase. Example: A regular generator that will give 210 volt DC to the magnet.

The EDP-A2 controller can be used on new installations or to replace old controller of several brands, even those installed directly on the generator, up to 20 kw.

It has two ways to take off: extend the iron or take off completely with the same control button.

It is not cast in an epoxy, so it is completely repairable. If it was cast in the epoxy, it would have to be discarded following a failure.

It is important for EDP Conception to do everything possible to promote sustainability and recovery!

It is designed entirely by EDP Conception, so you have access to comprehensive and accessible technical support, in both English and French.